Plate and Frame Oil Purifier LY100 Operation Manual

　　Plate and frame oil purifier LY100 operation manual is suitable for plate and frame oil purifier 30L/MIN, plate and frame pressure oil purifier 50L/MIN, plate and frame pressurized oil purifier 100L/MIN, LY plate and frame oil filter Used in plate steam turbine oil filtration and purification equipment such as 150L/MIN and BASY plate and frame oil filter 200L/MIN. Turbine oil filtration operating instructions are easy to understand, and the equipment is easy to use.

　　Plate and Frame Oil Purifier LY100 Operation Manual Picture:

　　The plate and frame oil filter can effectively remove a large amount of impurities and a small amount of water in industrial oil and mechanical oil. It is also used in oil depots (including factory oil depots) and related factories and enterprises for transformer oil, capacitor oil and various insulating material oils. The liquid is filtered to remove its moisture and impurities, and improve the compressive strength of the oil. For non-lubricating oils such as gasoline and kerosene, special materials and special motors can also be selected according to user needs. When there is too much water in the oil, the oil should be heated first to evaporate a part of the water before filtering. If the oil contains a lot of water, it can be used with our vacuum oil filter to achieve the purpose of dehydration and demulsification.

　　Plate and frame oil purifier LY100 adjustment and operation:

　　Before use, check the installation position of the filter plate and filter frame of the filter part. Starting from the thrust plate, the first piece is the plate, the second piece is the frame, the third piece is the plate, the fourth piece is the frame...and so on Arrange, the number of plates is one more than the frame. The plates and frames cannot be reversed. If they are installed reversely, they will not be able to filter. The grease coated on the plates, frames, thrust plates and compression plates must be removed. Before the test run, filter paper should be clamped between the plates and frames to press the plates and frames tightly.

　　Before starting the machine, the oil pump shaft must be rotated two or three times by hand. It is considered that the rotation is flexible and there is no card group phenomenon. Then connect the oil-resistant hose (or iron pipe) with the oil suction end and the oil discharge end of the oil filter, and then check the in and out Whether the oil pipe is blocked or leaking oil or gas, open the oil inlet and outlet valves, close the oil return valve and the pressure reducing valve (connected to the oil inlet and outlet ends of the oil pump), and then start the machine.

　　The correct rotation direction of the motor is the direction indicated by the arrow on the oil pump cover and gear pump nameplate, and it cannot be reversed.

　　If everything is normal, the oil pump will suck oil within a few seconds after starting up. If it still does not suck up oil within half a minute, it means that the suction end of the oil pump and the oil sample valve are leaking. You should stop working immediately and try again after troubleshooting to prevent gears. The pump is damaged when there is no oil.

　　If the value indicated by the pressure gauge is found to be as high as 0.4-0.6Mpa after the start-up, and the oil pump makes an abnormal noise, it should be shut down immediately to find out the fault and eliminate it.

　　Equipment export packaging: The conventional fumigation packaging is suitable for long-distance transportation abroad.

　　Equipment transportation methods: shipping, air transportation, automobile transportation, etc. The company will replace and repair the goods for free until the customer is satisfied with the accident during the transportation and loading.

　　Sales consulting: Manager Zhang 0086-18580036904 (same number on WeChat) 0086-02386194345

　　(Need more video training files, add mobile phone WeChat or phone consultation to learn more)

　　Delivery cycle: standard models are available in stock.