TY50 Turbine Lubricant Vacuum Oil Purifier Picture

　　Picture of TY50 Turbine Lubricant Vacuum Oil Purifier /MIN, turbine oil purification equipment 150L/MIN, ZJCQ turbine oil purification equipment 200L/MIN, ZJCQ turbine oil purification equipment 18000L/H and other steam turbine turbine oil filtration equipment reference The pictures of the turbine oil filter and the vacuum oil filter are rich in content, and original real pictures were taken on-site.

　　TY50 Turbine Lubricant Vacuum Oil Purifier Picture:

　　TY50 Turbine Lubricant Vacuum Oil Purifier Operation Manual Shutdown:

　　1. When it is necessary to stop, first turn off the heater (turn the heater rotary switch on the electric control cabinet panel to the "0" position, and the heater stops heating), and then close the oil inlet valve after 3 to 5 minutes. Open the drain valve, suck the oil in the heater and the water reservoir into the system for the next work. When the oil in the water reservoir has been sucked up, close the shutoff valve, stop the vacuum pump (the red button on the vacuum pump on the electric control cabinet panel) and open the valve. Lift the vacuum. After confirming that the oil in the system is exhausted, stop the oil pump (the red button of the oil pump on the panel of the electric control cabinet), restart the vacuum pump (the green button of the vacuum pump on the panel of the electric control cabinet), and run for 10 minutes to remove the water that settled in the vacuum pump oil , Stop the vacuum pump (red button on the panel of the electric control cabinet), turn off the power switch.

　　2. In case of emergency during operation, press the emergency stop button (red button/knob on the panel of the electric control cabinet) immediately, the machine will stop working, and close the oil inlet valve or open the ballast valve to release the vacuum. To resume work, open the oil inlet valve or close the ballast valve, and turn the emergency stop button (red button/knob on the panel of the electric control cabinet) to the right to reset;

　　In order to ensure that the equipment can be started at any time in the future, and there will be no performance changes during storage, we must take the following measures:

　　①. If you do not plan to use the oil filter multiple times within a short period of time, remove the oil inlet and outlet pipes.

　　②. Clean the oil filter and discharge the dirty oil. Put caps on the ends of all pipes to prevent dirt from entering.

　　③. Remove the power cord.

　　④. If the top cover is not equipped, the electric control cabinet door should be locked.

　　⑤ After the correct shutdown, the oil filter should be cleaned, drained and the equipment should be refilled with oil.

　　TY50 Turbine Lubricant Vacuum Oil Purifier Operation Manual Use and operation:

　　Preparation before operation

　　1. Connect the inlet and outlet oil pipes and inspection pipes;

　　2, connect the power supply line (AC380V/50Hz);

　　3. The oil inlet and outlet pipes are connected firmly, the phase sequence of the power supply line is correct, the power supply voltage matches the equipment, and the electronic control system is in standby state;

　　4. Check whether there are any factors affecting the operation of the equipment in the surrounding area and confirm that everything is normal before starting.

　　Equipment export packaging: The conventional fumigation packaging is suitable for long-distance transportation abroad.

　　Equipment transportation methods: shipping, air transportation, automobile transportation, etc. The company will replace and repair the goods for free until the customer is satisfied with the accident during the transportation and loading.

　　Sales consulting: Manager Zhang 0086-18580036904 (same number on WeChat) 0086-02386194345

　　(Need more video training files, add mobile phone WeChat or phone consultation to learn more)

　　Delivery cycle: standard models are available in stock.